"Combo11(0).Text=FSM - Treating Dermatomal Nerve Pain - Step 2  Remove The Basic Pathologies  From The Nerve"
"Combo11(1).Text=FSM - Treating Dermatomal Nerve Pain - Step 2  Remove The Basic Pathologies  From The Nerve"
"Text2=2"
"Text3=1"
"Text4=1"
"Text14=1"
"Text10=0"
"Text11=50"
"Text13="
"Text20=2.1"
"Text21=100"
"Text22(0)=0"
"Text22(1)=0"
"Text22(2)=1"
"Text22(3)=0"
"Text22(4)=0"
"Text22(5)=1"
"Text22(6)=0"
"Text25=100"
"Text27=0"
"Text28=Contact Mode - Maximum constant current of 500 uA
Right Hand/Side +ve  with  Left Foot/Side   -ve
Left Hand/Side   +ve  with  Right Foot/Side -ve

Remove the basic pathologies / from the nerve
970, 94, 321, 9 / 396

Remove the emotional component, remove nerve trauma, restore function, and remove histamine / from the nerve.

This sequence comes from Van Gelders concept of concussion as discussed in Chapter 10. In Van Gelders model, emotional shock and trauma leads to paralysis which leads to allergy reaction and reduction in secretions and vitality.

Emotional shock from an injury or trauma changes tissue function; 970 / takes the fact of this emotional shock out of the membrane.

Trauma stuns the nerve, overloading it rather like a power surge that trips a circuit breaker causing it to switch into something like a safe mode. The safe mode preserves the most important critical functions and allows for repair and recovery at some later time.

Paralysis does not refer to complete loss of function or true medical paralysis. The analogy to the loss of function when a computer locks up and loses the ability to move to the next step is most apt. The fact of the trauma interferes with the smooth transfer of information within the tissue that allows it to know what to do next. The frequency to remove paralysis is Van Gelders
conceptual equivalent of the computer command controlaltdelete that reboots the computer system.

Allergy Reaction refers to the bodys first response to any dysfunction which is to release histamine as a way of starting the inflammatory cascade. Removing the allergy reaction allows the
tissue to complete the return to normal function.

Note: These four frequencies are known collectively as The Basics. They are usually used in sequential order as a group combined with the channel B frequency for the injured tissue but each can be used individually as needed based on the patients condition.

Treatment time. Use each frequency for 1 to 2 minutes each. Current polarized positive.

*** Treatment application******************************

Current level
100300amps for the average healthy patient.
Use lower current levels of 2060amps for very small or debilitated patients. Current levels above this will be irritating and may make the patient restless or agitated.
Use higher current levels of 300500amps for larger or very muscular patients.
In general, higher current levels reduce pain more quickly and improve response.

Do not use more than 500amps as animal studies suggest that current levels above 500amps reduce ATP formation.
Current Polarized Positive +: Current is polarized positive for most nerve treatments except for shingles (see Chapter 9) and peripheral neuropathies which require alternating DC current.
Nerves respond very well and very quickly to polarized positive current.

Waveslope:

The waveslope refers to the rate of increase of current in the ramped square wave as it rises in alternating mode from zero up to the treatment current level every 2.5 seconds on the Precision Microcurrent and the automated family of FSM units. Other microcurrent instruments may have slightly different wave form choices. A sharp waveslope has a very steep leading edge
on the square wave shape indicating a very sharp increase in current. A gentle waveslope has a very gradual leading edge on the waveform indicating a gradual increase in current.
Use a moderate to sharp waveslope for chronic pain.
Use a gentle waveslope for acute pain or new injuries. A sharp waveslope is irritating in new injuries.

***** Lead placement ****************************

Positive leads.

The positive leads contact wraps around the neck or is placed along the spine at the exiting nerve root. The positive contact must cover at least the foramenal area where the nerve
exits the spine

Negative leads.

The negative leads attached to an adhesive electrode or wrapped in the warm wet fabric towel are placed at the end of the dermatome or nerve being treated. The placement is shown in the photographs.

Electrode Contacts. 

FSM typically uses graphite gloves to conduct the current but any conductor can be used as long as it has low resistance and can be wrapped around the spine at the exiting nerve root and have good contact with the distal end of the nerve being treated.

Adhesive electrode pads can be used if they are long enough (3 inches) to encircle the foramenal area where the nerve exits the spine and to give good contact at the distal end of the nerve.
The graphite gloves need to be kept moist so they conduct the current comfortably. The current will prickle and irritate if the gloves become dry.

Ref:  Frequency Specific Microcurrent by Carolyn McMakin - Pg 121


"
"Text29=0"
"Text31=16"
"Text32=0"
"Text33=16"
"Text37(0)=0"
"Text37(1)=0"
"Text41=5"
"Text44(0)=4"
"Text44(1)=10"
"Text45=1"
"Text7(0)=1"
"Text7(1)=1"
"Text7(2)=1"
"Text7(3)=1"
"Text7(4)=1"
"Text7(5)=8"
"Text7(6)=8"
"Text7(9)=1"
"Text7(10)=1"
"Text7(11)=0"
"Text7(12)=0"
"Text7(13)=0"
"Text7(14)=0"
"Text7(15)=0"
"Text7(16)=0"
"Text7(17)=0"
"Text7(18)=0"
"Text7(19)=0"
"Text7(20)=0"
"Text7(21)=0"
"Text7(22)=2"
"Text7(23)=2"
"Text7(24)=2"
"Text7(25)=2"
"Text7(26)=2"
"Text7(27)=2"
"Text7(28)=2"
"Text7(29)=2"
"Text7(30)=2"
"Text7(31)=2"
"Text7(32)=2"
"Text7(33)=0"
"Text7(34)=0"
"Text7(35)=0"
"Text7(36)=0"
"Text7(37)=0"
"Text7(38)=0"
"Text7(39)=0"
"Text7(40)=0"
"Text7(41)=0"
"Text7(42)=0"
"Text7(43)=0"
"Text7(44)=1"
"Text7(45)=0"
"Text7(46)=0"
"Text7(0)=1"
"Text7(1)=1"
"Text7(2)=1"
"Text7(3)=1"
"Text7(4)=1"
"Text7(5)=8"
"Text7(6)=8"
"Text7(7)=16"
"Text7(8)=16"
"Text7(9)=1"
"Text7(10)=1"
"Text7(11)=0"
"Text7(12)=0"
"Text7(13)=0"
"Text7(14)=0"
"Text7(15)=0"
"Text7(16)=0"
"Text7(17)=0"
"Text7(18)=0"
"Text7(19)=0"
"Text7(20)=0"
"Text7(21)=0"
"Text7(22)=2"
"Text7(23)=2"
"Text7(24)=2"
"Text7(25)=2"
"Text7(26)=2"
"Text7(27)=2"
"Text7(28)=2"
"Text7(29)=2"
"Text7(30)=2"
"Text7(31)=2"
"Text7(32)=2"
"Text7(33)=0"
"Text7(34)=0"
"Text7(35)=0"
"Text7(36)=0"
"Text7(37)=0"
"Text7(38)=0"
"Text7(39)=0"
"Text7(40)=0"
"Text7(41)=0"
"Text7(42)=0"
"Text7(43)=0"
"Text7(44)=1"
"Text7(45)=0"
"Text7(46)=0"
"Combo1.Text=Add F1 to F2"
"Combo2.Text=Frequencies Directly"
"Combo3.Text=08:01 pm"
"Combo4.Text=08:01 pm"
"Combo5.Text=Octal"
"Combo6.Text=Do NOT sort frequencies"
"Combo7.Text=Disabled"
"Combo8.Text=Disabled"
"Combo12.Text=Square Ramped"
"Combo14.Text=Square Ramped"
"Option30(0)=False"
"Option30(1)=False"
"Option30(2)=False"
"Option30(3)=False"
"Option30(4)=False"
"Option30(5)=False"
"Option30(6)=False"
"Option30(7)=False"
"Option30(8)=False"
"Option30(9)=True"
"Option30(10)=False"
"Option40(0)=False"
"Option40(1)=False"
"Option40(2)=False"
"Option40(3)=False"
"Option40(4)=False"
"Option40(5)=False"
"Option40(6)=False"
"Option40(7)=False"
"Option40(8)=False"
"Option40(9)=True"
"Option40(10)=False"
"Option40(11)=False"
"Option40(12)=False"
"Check2=0"
"Check3=0"
"Check6(0)=0"
"Check6(1)=0"
"Check6(2)=1"
"Check6(3)=0"
"Check8(0)=1"
"Check8(1)=1"
"Check8(3)=0"
"Check8(4)=0"
"Check8(5)=0"
"Check8(6)=0"
"Check8(7)=0"
"Check8(8)=0"
"Check8(9)=0"
"Check8(10)=0"
"Check8(11)=0"
"Check8(12)=0"
"Check8(13)=0"
"Check8(14)=1"
"Check9(0)=0"
"Check9(1)=0"
"Check12(0)=0"
"Check12(2)=0"
"Check13=0"
"Check15(0)=0"
"Check16=0"
"Check22=0"
"Label17="
"List2=FSM - Emotional Shock 970 Hz OUT1 + Dermatonal or Peripheral Nerves 396 Hz OUT2 (CUST)"
"List2=FSM - Trauma 94 Hz OUT1 + Dermatonal or Peripheral Nerves 396 Hz OUT2 (CUST)"
"List2=FSM - Paralysis 321 Hz OUT1 + Dermatonal or Peripheral Nerves 396 Hz OUT2 (CUST)"
"List2=FSM - Histamine 9 Hz OUT1 + Dermatonal or Peripheral Nerves 396 Hz OUT2 (CUST)"
"List4=970 f0c 396=180"
"List4=94 f0c 396=180"
"List4=321 f0c 396=180"
"List4=9 f0c 396=180"
"List5=970;;180;;;;;;;;;0;396;;;;;;;;"
"List5=970;;180;;;;;;;;;0;396;;;;;;;;"
"List5=94;;180;;;;;;;;;0;396;;;;;;;;"
"List5=94;;180;;;;;;;;;0;396;;;;;;;;"
"List5=321;;180;;;;;;;;;0;396;;;;;;;;"
"List5=321;;180;;;;;;;;;0;396;;;;;;;;"
"List5=9;;180;;;;;;;;;0;396;;;;;;;;"
"List5=9;;180;;;;;;;;;0;396;;;;;;;;"
